RVParkSupplies.com
Visa, Master Card, Discover Card, American Express
Please Login    
Enhanced Search

Bookmark this page

3 ft Rubber Garage Parking Stop with White Stripes

3 ft Rubber Garage Parking Stop with White Stripes
Part # 3FTRCSWHT

Volume Pricing
From: $19.95  
31-59 60+
 $19.95   $15.95 

Suggested Retail Price: $37.00

Minimum Quantity: 
(31 or more must be purchased.)

Great price while quantities last! Our 3 ft Rubber Garage Parking Stop with 2 white stripes helps drivers know when to stop. Tough, recycled tire rubber is resistant to weather, salt, moisture, UV, oil and temperature. Will not warp, chip or crack. Reflective stripes are made of road marking tape. Easy, one person installation (instructions included).

Two mounting holes.

Two white stripes on each side.

Installation hardware is available but sold separately.

Please see below for asphalt and concrete installation hardware.

Please call for freight quote on multiple quantities.

Weight 20 lbs.

Dimensions: 6" W x 4.25" H x 3 feet L.

Manufactured in the U.S.A. to keep Americans working.

Rubber Garage Parking Stop Installation Instructions:

Mounting Rubber Garage Parking Stops on Asphalt:
1. Drill 1/2" diameter pilot holes through asphalt or to depth of 3".
2. Clean installation area.
3. Put rubber wheel stop in place. Put washers in place.
4. Start asphalt rebar spikes before completely setting any individual rebar spike.

Mounting Rubber Garage Parking Stops on Concrete:
1. Drill 3/4" holes, 2" deep and insert lag shield (threaded end goes in first). For maximum expansion, the shield should protrude slightly above concrete surface before setting.
2. Clean installation area.
3. Put product in place. Put washers in place.
4. Insert lag screw starting all lags before tightening any. Tighten with wrench until firm resistance is felt.

Mounting Rubber Garage Parking Stops with Adhesive:
1. Use 10 ounces of construction grade adhesive such as PL Premium Polyurethane or a 2-tube epoxy such as Simpson ET-22. These products can be bought from your local hardware store.
2. Put rubber wheel stop in place. Mark perimeter and drill holes.
3. Brush holes and blow out debris. Clean and dry installation area to adhesive directions.
4. Mix enough epoxy for one installation (if using a 2-tube epoxy) or use a 10 oz. tube of PL Premium.
5. Fill the holes to 2" from top with adhesive.
6. Apply adhesive to bottom of wheel stop. Set in place.
7. Install washers and hardware (see instructions above).
8. Allow setting and curing time according to adhesive directions. Please note if you remove parking stop installed with adhesive, you are likely to tear the wheel stop or the surface.



Related Item(s)

Go to top of this 3 ft Rubber Garage Parking Stop with White Stripes page.




Visa, Master Card, Discover Card, American Express PayPal

Home  |  Our Mission  |  Contact Us  |  Privacy Policy  |  Shipping  |  Returns